Move the SLIDER up-and-down to your prefered
blind height. when resistance is felt STOP. A slight
adjustment of the SLIDER makes the blinds tilt.
WHEN RAISING THE BLINDS – ENSURE SLATS ARE IN THE OPEN POSITION
RE-ALIGNMENT OF VENETIAN SLATS
Open the blinds, then raise the SLIDER up and
down to re-align.
RE-ENGAGING THE OPERATOR(S)
Due to the nature of the magnetic design, disegagement
of the raise & lower SLIDER can occur by applying
excessive force / by lifting the SLIDER away from the
surface of the glass / by moving the SLIDER out of its
designed track. This action may release the magnetic bond,
out of its designed track. thus causing the blind to
temporarily malfunction. This occurrence is easy to correct…
TO RE-ENGAGE THE MAGNETS & RESTORE NORMAL OPERATION, SIMPLY LIFT THE SLIDER UP, IN ITS TRACK, UNTIL THE MAGNETS RE-ENGAGE. YOU WILL HEAR THEM CONNECT.
SOME MODELS ARE FITTED WITH 2 SLIDERS
TOP ADJUSTS THE TILT ACTION,
LOWER CONTROLS THE BLIND HEIGHT
If you have a 2 or 3 magnet side SLIDER (2 ” or 3” tall), one magnet click will restore operation – SEE DIAGRAM A
If your blind uses a 4 magnet SLIDERS (3 ” tall), then a second engagement point (second magnet click) is required – SEE DIAGRAM B
This second engagement is achieved by pushing the side SLIDER up again past this ﬁrst engagement point until you hear the second click. If all magnets within the SLIDER, and inside the unit are not aligned, then full engagement will not be restored.